Unit was turned off. Plugged in compressor started. Checked amperage. .9 good High pressure line is getting hot as should. Compressor sounds normal. Put into service diagnostics. All tests checked good. Condenser and evaporator fans are running. Unit is cooling checked temperature at one point. 17 degrees and falling. Signed disclaimer. Told customer not to unplug unit if further issues occur. Ran unit long enough that bimetal closed for defrost cycle. Is heating. Customer paid service call $149.95 auth code. X9FE39 Please fill out whirlpool tech satisfaction survey. Thank You.

Customer signed disclaimer. Replaced icemaker. Put thru a cycle it filled fine. Customer needs to discard the first couple of cycles of ice. Then can use. Working as should. Please fill out whirlpool tech sayisfaction survey. Thank You.

Customer signed disclaimer. Drain pump not running. Removed it was damaged. Replaced W11497943 and test in diagnostics. Cleared F9E1 code. Unit went thru just fine. Drained good. Took pic of leak board. Please fill out whirlpool tech satisfaction survey. Thank You.; used 1 W11497943 (Drain Pump (DW)) from stock

Customer signed disclaimer. Unit is running. Compressor running but cooling very little. Removed cover over compressor installed a BPV 31 valve on service port. Unit low on 600 Put some in unit to charge then checked for a leak in lines and compressor as well as evaporator none apparent with gas leak detector. Remove gas then put a vacuum to system. Let set for awhile held a vacuum. Recharged system. Did a bubble test of all joints in evaporator and compressor area. Lo side -6 Hi compressor amperage. .80 good. Is cooling good. Please fill out whirlpool tech satisfaction survey. Thank You. ; used 1 BPV 31 (Valve) from stock

Installed lower wash arm. Operating as should. Please fill out whirlpool tech satisfaction survey. Thank You.