Signed disclaimers. Unit evaporator is iced over. Not defrosting as should. Put into service diagnostics test defrost cycle. Checked amperage of heater none. Checked wire harness connections of heater found the hot side not snapped into the connector was out. Reconnected properly so snapped in place. Checked amperage again 1.05 good. Operating as should. Completely thawed out evaporator of ice. Put a zip tie and wrapped thermistor with aluminum tape. Please fill out whirlpool tech satisfaction survey. Thank You.

"Customer signed disclaimer. Evac system, Replaced drier,compressor and overloadrelay. Installed couplers. Evac system again. Recharge system lo side -6 hi side 45 good. compressor amperage .79 good. Put a leak board under unit."

"Evap frozen over thawed out. Replaced elec control, def heater and harness as well as evap thermistor used zip tie to hold in place and wrapped with silver tape. Unit operating as should. Please fill out whirlpool tech satisfaction survey. Thank You."

Adjusted top burners too high on low. Checked temp sensor 1076 at sensor and is not grounded. Checked at control 1076 not grounded. Good. Calibrated my meter 32 degrees in ice water. Checked oven temp 400 degrees. Meter probe in center of oven. checked Hi 400 lo 388 hi 402 lo 387 hi 402 lo It is running a bit cool did a +5 degree offset. Shows customer how to do. customer signed waivers. Please fill out whirlpool tech satisfaction survey. Thank You.

Replaced bake igniter. Test operation. It is good. Please fill out whirlpool tech satisfaction survey. Thank You.