DCS Repair Jobs and Surveys

Found unit needing igniter coil and spark module. Coils are nla. Cust declines repair. Collected 159.95 $183.94 CC Auth# P4NT4R

Center burner gas valve failed. Need part 250072P. Nuts and bolts rusted and breaking. Not worth repairing. Service fee $159.95 paid autho 4A9R3E

Installed ordered parts tested ops all ckok collected 269.95 $283.45 CC Auth# MW9N93

UNIT IS WORKING AS INTENDED.

Adjusted burner cap so flame propagates correctly. Collected 159.95

installed part and unit checked okay...autho no. YF9M43

"Installed replacement switch, unit check ok charged labor as quoted. $249.95 CC Auth# 3Y3RWU"

"UNIT HAD A WIRE THAT CAME OFF THE CONNECTOR, REPLACED CONNECTOR AND REATTACHED THE WIRE TO THE THERMAL CUTOUT, UNIT STARTED HEATING AND UNIT CHECKED OKAY, CARD SHOWED 3DIGIT WAS INVALID CALLED AMANDA"

installed all parts sent ran test op all ok at this time.

"INSTALLED PART, AND UNIT CHECKED OKAY"

Complaints of all-gas unit losing pilot flames and manually having to relight; left oven igniter doesnt function. Unit is about 25 years old and tech support was unable to give assistance or part numbers. Charged service call. $149.95 CC Auth# 4CKE3U

"Arrived 2:36, no answer to phone or door, rang/knocked. Will have to call to reschedule. Closing."

"Arrived 2:36, no answer to phone or door, rang/knocked. Will have to call to reschedule. Closing."

"Cavity lights do not run, bezels 3 and 4 stuck on. Per techline bezels 1 and 2 are causing 3 and 4 to light, so Cust would need 2 bezel replacements. Cavity lights apparently have possible pinch in wiring? FP gave wrong part number for cavity light wire harness. Must try to reach FP and get wire harness with light assemblies part numbers, then call Cust with quote.251621 bezel $233.92251977 light wire harness (bad p/n)$159.95 CC Auth# 4CJNF9"

Installed ordered part. Tested operations all ckok. Still waiting on tube but it will be shipped directly to cust. Per office cust paid in full for job.

"burner bases were not set correctly, cust to monitor...cust paid in full autho no. JRX393"

"Found unit not heating due to faulty thermal limiter. Needs thermal limiter 245915 119.52+tax, labor 209.95, sc 119.95, mps 14.50. Total: 473.72/263.77 due today remainder due on completion; ordrng 1 245915 (Thermal limiter)"

replaced listed part and unit chekcedc okay

replaced listed part and unit chekcedc okay

replaced listed part and unit chekcedc okay