Dacor Repair Jobs and Surveys

INSTALL/ TEST: PASS - OK!?CX WILL USE LIVE TO SEE IF TEMPS ARE ACCURATE FOR ENTIRETY OF COOKINGCX CLAIM TEMPS ARE ACCURATE ON LOWER OVEN BUT OFF BY 20* IN UPPER OVEN ( TEMP OFFSET IS UNIVERSAL NOT BY CAVITY)JOB COMPLETE

8/6/26 BA: CC unit is not heating properly. Tech tested the oven at a pre heat of 350 degrees. During operation the oven reached max temperature and did not cycle off at the desired temps. Relay switches on main board have failed and board will need to be replaced. Unfortunately part # DE81-05671A is NLA. Tech will found out if a double oven relay board can work with a single oven since Cx might source part from eBay.

Replace tinges and tested operation.All checks okay

INSTALL VALVE STEM AND KNOBTEST: PASSJOB COMPLETECX NOT AVAILABLE FOR SIGNATURE

"UNIT ONLY REQUIRED A NEW INVERTER, REPLACED THE PAR AND UNIT CHECKED OK. CUST IS GOING TO BE REFUNDED 526.99"

"Replace water filter housing assembly and installed new filter, tested and all checks okay and no lease detected at time of service."

replaced micro switch and tested operation all checks ok

Connect to HASS Run diagnostic and icemaker test:pass

Preheat oven to 400 degrees and let run for 30 min.UI panel is still warm/hot to the touch after 2 hoursCall dacor tag: engineering explains that panel can reach up to one hundred and fifty degrees.

"Found weak bake element lower oven, calibrated lower, part is NLA, svf paid $169.95 CC Auth# 9XUH9C"

"Adjust simmer control on valve stem, unit attempting to reignite when on ultra low setting."

JG June 30th 1:07 PM contacted client informed her Im on my way and my ETA is 1:45 PMClient doesnt know why a door lock was sent. Her issue was pans not properly heating evenly. I did test door lock via child lock mode and verified the door locks and unlocks fine. Looked over user manual and found the following issues : client is not using correct pans sizes for the burner they are using. Pans are too small and are not filling the minimal line indicated in book/ cook top. The cast iron pan failed the leveling (ruler test) in booklet. Pans also do not have induction compatibility noted on the backside. All heaters do work and are sensing pans. Spoke with tech support who agree this is a costumer education situation and no machine fault found Client states door lock

"Install panels and kick plate, stay. Adjust installation hardware for sidemount job complete"

"Install p c b power up reinstall, test job complete"

"123.6v into main board, no response or lights on buttons. Board no longer available unit is 22 years old. Service fee $169.95 paid autho T43ET3"

Replace filter board. Test op. Unit working as expected. All okay. Collect 279.95. $279.95 CC Auth# 94FYJ9

Cycle tested unit found auger stuck corrected all tested fine at this time customer paid service fee by credit card. Authorization number 4P99NH. Trans#4215162

"Bad ice maker needs new ice maker, replaced ice maker and cycled. Service Fee $169.95 + Labor $239.95 + Parts/Shipping $172.64 + Tax $14.16 + MPS $18.50 = TOTAL $615.20$615.20 CC Auth# 3KY93W "

$229.95 CC Auth# WJ3C34Install part. Test op. All okay.

Replaced the bottom base have to take machine whole apart to do that unwired the control took board out out new base in install all wires level the machine raise legs ran hass and it passed