Signed disclaimer. When dispensing water and ice will continue after removing cup. Replaced switch and separator. Reassembled unit and test operation is operating as should. Please fill out whirlpool tech satisfaction survey. Thank You.

Signed disclaimer. Removed front blower housing Found felt seal on bottom side shoved in too far repositioned it so was around transition duct lip properly. Run unit a good while I wiggled and shook unit did not make any unusual sound. Is operating as should. Please fill out tech satisfaction survey. Thank You.

"Signed disclaimer, Replaced all parts listed. Dis a calibration ok. Then do a quick test ok. Unit operating as should. Put a leak board under unit took pic."

checked unit MN/SNcustomer signed disclamer.put unit into test mode and ran error codes got a code 2 - 1 stuck key. reset codes and ran a service test.user interfase test = all buttons tested good.calibrated.checked unit vent. found no problems.unit passed service test with no errors. found no aditional problems. and could not replicate problem.customer paid auth # 4CR9UFplease fill out a tech servey

checked unit MN/SN POPcustomer signed disclamer.unhooked unit and removed door panel.unhooked and removed display control and removed facia panel .Installed new facia and reassembled unit.puit door panel back on unit and restored power.tested that the unit functions.unit tested good.please fill out a tech servey.