replace control panel and setup. test op's ok. customer needs to pay $169.00 labor to replace control and test op's customer to call when has access to card.

put into service diagnostics F0E1Load in drum during clean cycle. cleared code. test 12 went thru no codes at end of test. sounds good during drain and spin. Put a load in unit. quick wash. went thru cycle. balanced load then went into spin at 2 minutes. customer had set spin speed at mid. Did just fine. no issues. removed rear panel and checked struts all ok. also rotor is tight on motor. too heavy load or too lite of loads can create out of balance loads. unit will try to balance load but if it cant it will shut down and not finish cycle. loads are critical to proper operation of unit.

removed unit and checked wire harness to control panel and main control. checked ok. F2 E1 indicated stuck key will need to replace UI asy. W11232102 $922.85 labor to repair $169.00 Paid Service call $209.00 other $17.50 tax 75.67 total $1394.02 Authy code X4K3MM