Checked the unit MN SN POP Customer signed disclaimer disconnected power Removed the top glass and unhooked the large burner.Placed in the new burner and hooked it up and installed it .Reassembled the unit. Restored the power and tested.This unit is operating as designed by factory.If you are satisfied with the service I have provided you with today then please share your experience with others by going online to D-3 A-OK Appliance service inc and filling out a technician survey.Your technician.Sean.

Checked the unit MN SN POP Customers signed the disclaimer.Checked the package good The unit was already pulled out and unplugged .I removed the screws holding the CONFIGURED MACHINE CONTROL BOARD.Unplugged the control and removed the board from the unit.Unpackaged the new board and installed it into the unit.Reconnected all the wiring and reassembled the unit.Put it back into place and tested.The unit starts out a drain for a few seconds and starts to run the cycle. This unit is operating as designed by factory.If you are satisfied with the service I have provided for you today. Than please share your experience with others by going online to D-3 A-OK Appliance service inc. and filling out a technician survey. It really helps to let everyone know how I did.Thank you Technician. Sean.

Installed gaskets sealed area really well. Is dispesing and making ice. Please fill out whirlpool tech satisfaction survey. Thank You.

Strike and latch broke. Replaced. Cleared error codes. Test run operation is normal. Customer signed waivers. Please fill out whirlpool tech satisfaction survey. Thank You.

Removed evap cover in fresh food area. Water reservoir is frozen. Thawed out and test dispenser and ice maker. op's is normal. Sealed evaporator foam cover with permagum where air blows into tower. To keep air from water reservoir. ok. Reassembled unit. Please fill out whirlpool tech satisfaction survey. Thank You.